Advisory Circulars

Specifies minimum requirements for an Airport Lighting Control and Monitoring System (ALCMS), which simplifies the control and monitoring of lighted visual aids and enhances airport safety.

Contains the specifications requirements for series-to-series isolation transformers for use in airport lighting systems.

Provides guidance for using the standardized International Civil Aviation Organization (ICAO) method to report airport pavement strength. The standardized method is known as the Aircraft Classification Number – Pavement Classification Number (ACN-PCN) method.

Contains the Federal Aviation Administration standards for the siting and installation of signs on airport runways and taxiways. Incorporates mandatory hold signs that reflect changed standards for the Precision Obstacle Free Zone (POFZ) and Category (CAT II/III) operations. Includes sign standards to assist airport operators in designating (1) the POFZ holding position in those instances where a taxiway, holding apron, or other movement area would result in an aircraft fuselage or tail penetrating, and (2) the alternative holding position on a taxiway during CAT II/III operations necessary to maintain adequate aircraft separation.

Describes the standards for markings used on airport runways, taxiways, and aprons.

Provides standards for the construction of airports. Items covered include general provisions, earthwork, flexible base courses, rigid base courses, flexible surface courses, rigid pavement, fencing, drainage, turfing, and lighting installation. See Errata Sheet below.

Because of the size of this document, it is available as a single file (see Complete) or as three smaller files (see Parts 1-3). See Construction Standards for Airports to access individual files for each item or part.

Provides standards for the construction of airports. Items covered include general provisions, earthwork, flexible base courses, rigid base courses, flexible surface courses, rigid pavement, fencing, drainage, turfing, and lighting installation. This version adds Item P-632, Bituminous Pavement Rejuvenation.

Because of the size of this document, it is available as a single file (see Complete) or as three smaller files. See Construction Standards for Airports to access individual files for each item or part.

See below for access to revised Item P-620, Runway and Taxiway Painting, and new Item P-621, Saw-Cut Grooves, from AC 150/5370-10E.

Version E updates Item P-620, Runway and Taxiway Painting, to include new information on Preformed Thermoplastic Airport Pavement Markings and Application—Preformed Airport Pavement Markings; clarifies that Prohibited Materials cannot exceed permissible limits as specified in relevant Federal Regulations; adds Item P-621, Saw-Cut Grooves; and updates references to Saw-Cut Grooves in Items P-401, Plant Mix Bituminous Pavements, and P-501, Portland Cement Concrete.

Because of the size of this document, it is available as a single file (see Complete) and as three smaller files. See Construction Standards for Airports to access individual files for each item or part.

Access related Pay Reduction Spreadsheets on our Airport Design Software page.

Provides guidance on the use of nondestructive testing equipment to evaluate the load-carrying capacity of airport pavements.

Provides guidance to planners and communities interested in developing a civil vertiport or vertistop.

Provides guidance for the selection of a water source and standards for the design of a distribution system to support aircraft rescue and firefighting (ARFF) service operations on airports.

The AC was cancelled for the following reason. The primary reference upon which the document is based, National Fire Protection Association (NFPA) 419 - Guide for Master Planning Airport Water Supply Systems for Fire Protection, was cancelled in 1996. The relevant information from that specification has been inserted in other NFPA standards. Therefore, the AC is no longer necessary as water supply safety is ensured through a variety of other guidance material used by airport operators and architectural and engineering firms.