« Back to Advisory Circulars main page

Will search within "Certification Procedures for Products and Parts" only. Search all ACs.

26 - 30 of 30 results.

Export to MS Excel

Search results
Number Office Title Date
21-48 AIR-100 Using Electronic Modeling Systems as Primary Type Design Data

This AC provides information and guidance on developing procedures for using electronic modeling systems in design, manufacture, installation, and inspection processes.  It applies to applicants for Type Certificates (TCs), Amended Type Certificate (ATCs), Supplemental Type Certificates (STCs), Parts Manufacturer Approval (PMA), Technical Standard Order Authorizations (TSOA), major alterations, and major repairs.  In this AC, we explain how you can submit a proposal to use electronic modeling system data instead of (or in addition to) traditional paper format for the technical data required for initial and post certification activities.  We identify the minimum criteria for using electronic type design data, and include requirements for how to access and present the data.  In this AC, we define an “electronic modeling system” as a three?dimensional (3-D) modeling system.

 For Federal Aviation Administration (FAA) certification applicants, this AC mirrors our procedures in Order 8000.79, Use of Electronic Technology and Storage of Data, and Guide FAA-IR-01?01A, Aircraft Certification Guide for the Use of Electronic Technology and Alternative Methods of Storing Information. This AC must be used in conjunction with Order 8000.79 and Guide FAA-IR-01-01A.

 This AC is not mandatory and does not constitute a regulation.  We describe acceptable means, though it is not the only means, for using electronic modeling systems in design, manufacture, installation, and inspection processes.  If you use the means described in this AC, you must follow it in its entirety

10-29-2010
21-29C AFS-350 Detecting and Reporting Suspected Unapproved Parts Including Changes 1 and 2

 This advisory circular (AC) provides updated information and guidance to the aviation community for detecting suspected unapproved parts (SUP) and reporting them to the Federal Aviation Administration (FAA). Appendix 1 contains FAA Form 8120-11, Suspected Unapproved Parts Reports, which serves as a standardized means of reporting.

07-22-2008
21.25-1 ACE-111 Issuance of Type Certificate: Restricted Category Agricultural Airplanes Provides information and guidance for obtaining a type certificate in the restricted category under Title 14 of the Code of Federal Regulations (14 CFR) Part 21, Section 21.25, for small single-engine piston and turbo-propeller driven airplanes, which will be used for agricultural special purpose operations. It also provides an acceptable means, but not the only means, of meeting the requirements of 14 CFR part 21 for the issuance of a type certificate in the restricted category. 12-01-1997
21.17-1A ACE-100 Type Certification-Airships Describes two acceptable criteria for the type certification of airships that may be used by an applicant in showing compliance with section 21.17(b) of the Federal Aviation Regulations (FAR),Part 21. General guidance relative to airship type certification is also provided. 09-25-1992
21.17-2A ACE-100 Type Certification-Fixed Wing Gliders (Sailplanes), Including Powered Gliders Provides information and guidance concerning acceptable means of showing compliance with Section 21.17(b) of Part 21 of the Federal Aviation Regulations (FAR) for type certification of gliders and powered gliders. General guidance relative to glider type certification is also provided. 02-10-1993

26 - 30 of 30 results.

Export to MS Excel