Airworthiness Standards: Normal, Utility, and Acrobatic Category Airplanes
Large AC] Evaluation of Flight Loads on Small Airlpanes with T, V, +, or Y Empennage Configurations
Provides information and guidance concerning compliance with Part 23 of the Federal Aviation Regulations (FAR) applicable to evaluation of empennage design flight loads on configurations where the horizontal tail surfaces are supported by the vertical tail, or have appreciable dihedral.
Flight Test Guide for Certification of Part 23 Airplanes
a. This advisory circular (AC) sets forth an acceptable means, but not the only means, of showing compliance with Title 14 of the Code of Federal Regulations (14 CFR) part 23 concerning flight tests and pilot judgements. Material in this AC is neither mandatory nor regulatory in nature and does not constitute a regulation.
b. This AC is one method being utilized to achieve national standardization in normal, utility, acrobatic, and commuter category airplanes. This AC applies to Subpart B and various sections under Subparts A, D, E, F and G from § 23.1 through § 23.1589. This AC consolidates existing policy documents, and certain ACs that cover specific paragraphs of the regulations, into a single document.
c. This material is intended as a ready reference for part 23 airplane manufacturers, modifiers, Federal Aviation Administration (FAA) design evaluation engineers, flight test engineers, and engineering flight test pilots, including Organization Delegation Option (DOA).
This advisory circular (AC) sets forth an acceptable means of showing compliance with Title 14 Code of Federal Regulations (14 CFR) part 23 and Civil Air Regulations (CAR) 3 for the flammability testing of systems and equipment in normal, utility, acrobatic, and commuter category airplanes and airships. This AC applies to Subparts D and F of part 23 and applicable sections of CAR 3 as listed in Paragraph 6a. The revision addresses systems and equipment and references other general ACs that provide guidance for other subparts of part 23.