|25.856-1||ANM-115||Thermal/Acoustic Insulation Flame Propagation Test Method Details Guidance applies to airplanes required to conform with 25.856, and part VI of appendix F to Title 14 Code of Federal Regulations (14 CFR) part 25.||06-24-2005|
Transport Airplane Cabin Interiors Crashworthiness Handbook
This Advisory Circular (AC) provides acceptable certification methods, but not necessarily the only acceptable methods, for demonstrating compliance with the crashworthiness requirements of part 25, as amended through Amendment 25-112, of Title 14 of the Code of Federal Regulations (14 CFR) for transport category airplanes. The guidance in this AC is not mandatory nor a regulation.
|25-18||ANM-114||Transport Category Airplanes Modified for Cargo Service Provides guidance for demonstrating compliance with the FAR pertaining to transport category airplanes converted for use in all-cargo or combination passenger/cargo (combi) service and the relationship of those regulations to the requirements of Parts 121and 135 of the FAR.||01-06-1994|
|25.807-1||ANM-114||Uniform Distribution of Exits Provides guidance material for acceptable means, but not the only means, of demonstrating compliance with the requirements for distributing required passenger emergency exits uniformly. Addresses only those passenger-carrying airplanes, including mixed passenger/cargo (“combi”) configurations, with a type certification basis for Amendment 25-15 or later with respect to Section 25.807(c) or airplanes with an earlier type certification basis required by Section 25.2 to meet Section 25.807, Amendment 25-15. Does not address airplanes with only one pair of required exits.||08-13-1990|
|25.1455-1||ANM-112||Waste Water/Potable Water Drain System Certification Testing Sets forth a specific method of compliance with the requirements of section 25.1455 of the FAR pertaining to draining of fluids through drain masts when the fluids are subject to freezing. This method is designed to verify that draining fluids will not accumulate as ice in sufficient quantity to be hazardous. Is for guidance purposes and to set forth one method of compliance that has been found acceptable.||03-11-1985|
|25.775-1||ANM-110||Windows and Windshields Sets forth an acceptable means, but not the only means, of demonstrating compliance with the provisions of Title 14, Code of Federal Regulations (14 CFR) part 25 pertaining to the certification requirements for windshields, windows, and mounting structure. Guidance information is provided for showing compliance with § 25.775(d), relating to structural design of windshields and windows for airplanes with pressurized cabins. Terms used in this AC, such as “shall” or “must,” are used only in the sense of ensuring applicability of this particular method of compliance when the acceptable method of compliance described herein is used. Other methods of compliance with the requirements may be acceptable. While these guidelines are not mandatory, they are derived from extensive Federal Aviation Administration (FAA) and industry experience in determining compliance with 14 CFR. This AC does not change, create any additional, authorize changes in, or permit deviations from, regulatory requirements.||01-17-2003|