|120-29A||AFS-400||Criteria for Approval of Category I and Category II Weather Minima for Approach This AC provides an acceptable means, but not the only means, for obtaining and maintaining approval of CAT I & II Weather Minima including the installation and approval of associated aircraft systems.||08-12-2002|
|120-33||AFS-400||Operational Approval of Airborne Long-Range Navigation Systems for Flight within the North Atlantic Minimum Navigation Performance Specifications Airspace Sets forth acceptable means, but not the only means, for operators certificated under FAR Parts 121 and 123 and operators utilizing large aircraft under FAR 135.2, to obtain approval to operate within a specific airspace over the NAT (North Atlantic) MNPS (Minimum Navigation Performance Specifications) airspace after 0001 Greenwich Mean Time, Dec. 29, 1977.||06-24-1977|
|120-41||AFS-400||Criteria for Operational Approval of Airborne Wind Shear Alerting and Flight Guidance Establishes an acceptable means, but not the only means, of obtaining operational approval of an airborne wind shear alerting and flight guidance system. It describes acceptable simulation test criteria, wind field modeling data, and minimum performance parameters for evaluating candidate systems.||11-07-1983|
Air Carrier Operational Approval and Use of TCAS II
This advisory circular (AC) provides an acceptable, but not the only, means to address Traffic Alert and Collision Avoidance System (TCAS) issues related to installation and use of TCAS II regarding compliance with Title 14 of the Code of Federal Regulations (14 CFR) parts 121, 125, and 129 requirements for air carriers.
|120-57A||AFS-400||Surface Movement Guidance and Control System Describes the standards and provides guidance in the development of a Surface Movement Guidance and Control System (SMGCS) plan for U.S. airports where scheduled air carriers are authorized to conduct operations when the visibility is less than 1,200 feet runway visual range.||12-19-1996|
|120-67||AFS-400||Criteria For Operational Approval of Auto Flight Guidance Systems States an acceptable means, but not the only means, for obtaining operational approval of the initial engagement or use of an Auto Flight Guidance System (AFGS) under Title 14 CFR part 121, section 121.579(d); part 125, section 125.329(e); and part 135, section 135.93(e) for the takeoff and initial climb phase of flight.||03-18-1997|
Guidelines for the Certification, Airworthiness, and Operational Use of Electronic Flight Bags
This joint Flight Standards Service (AFS) and Aircraft Certification Service (AIR) advisory circular (AC) contains guidance on the operational use of Electronic Flight Bags (EFBs). It is intended for all operators conducting flight operations under Title 14 of the Code of Federal Regulations (14 CFR) part 121, 125, 135, or 91 subpart F (part 91F) and part 91 subpart K (part 91K) who want to replace required paper information or utilize other select functions of an EFB. This AC sets forth an acceptable means, but not the only means, to obtain Federal Aviation Administration (FAA) authorization for the operational use of EFBs. Part 91 operators can find additional EFB information in the current edition of AC 91-78, Use of Class 1 or Class 2 Electronic Flight Bag (EFB). For guidance on the installation of EFB components, refer to the current edition of AC 20-173, Installation of Electronic Flight Bag Components.
|120-91||AFS-400||Airport Obstacle Analysis Describes acceptable methods and guidelines for developing takeoff and initial climb-out airport obstacle analyses and in-flight procedures to comply with the intent of the regulatory requirements of Title 14 of the Code of Federal Regulations part 121,§§ 121.177, 121.189, and part 135, §§ 135.367, 135.379 and powered airplanes operated under parts 121 and 135||05-05-2006|
Continuous Descent Final Approach
This advisory circular provides guidance for all operators using the continuous descent final approach (CDFA)technique while conducting a nonprecision Approach (NPA) procedure. It describes the rationale for using the CDFA Technique, as well as recommended general procedures and training.
Foreign Terminal Instrument Procedures (FTIP) Acceptance/Review
This advisory circular (AC) establishes guidelines for U.S. operators to use when reviewing Foreign Terminal Instrument Procedures (FTIP). Occasionally, the author uses the word "must" or similar language when he deems the desired actions critical. The Federal Aviation Administration (FAA) does not intend for the use of such language to add to, interpret, or relieve a duty imposed by Title 14 of the Code of Federal Regulations (14 CFR).
Operational Authorization Process for use of Data Link Communication System
This advisory circular (AC) presents various methods for operators of different data link systems to meet international standards set by the International Civil Aviation Organization (ICAO) and the regional airspace authorities. The Federal Aviation Administration (FAA) notes that there is presently no requirement in Title 14 of the Code of Federal Regulations (14 CFR) to have data link communications when operating in the National Airspace System (NAS). Instead, the regulations in 14 CFR govern radio communication systems, and nothing in this AC relieves an operator from the requirement to have and use a voice communication system when operating in international airspace or the NAS. However, operators that choose to operate in a reduced separation standard that requires the use of a data link system (in addition to the required voice communication system) must obtain FAA design approval and a revision to their 14 CFR part 121, 125, 125M, or 135 operation specifications (OpSpecs), part 91 subpart K (part 91K) management specifications (MSpecs) or part 91 letter of authorization (LOA), as applicable. The original AC 120-70 was applicable to Aeronautical Telecommunication Network (ATN), very high frequency (VHF) data link (VDL) Mode 2 communication systems. The Future Air Navigation System (FANS) 1/A system used in oceanic and remote airspace is an analog system which communicates over Aircraft Communications Addressing and Reporting System (ACARS). Guidance is needed for the operation of all systems and therefore the first revision AC 120-70A, was created.
Pilot Records Improvement Act of 1996
The Pilot Records Improvement Act of 1996 (PRIA), as amended, was enacted to ensure that air carriers and air operators adequately investigate a pilot’s background before allowing that pilot to conduct commercial air carrier flights. Under PRIA, a hiring employer cannot place a pilot into service until he or she obtains and reviews the last 5 years of the pilot’s background and other safety-related records as specified in PRIA.
This advisory circular (AC) is supplemented by the current edition of Federal Aviation Administration (FAA) Order 8000.88, PRIA Guidance for FAA Inspectors, and numerous other documents found on the PRIA Web site at http://www.faa.gov/pilots/lic_cert/pria. These sources of detailed information related to PRIA provide invaluable assistance to the certificate holder or others concerning the PRIA request process as well as other compliance issues.
The FAA has greatly expanded this AC from the previous version to address operational situations that the hiring employer may encounter that could affect his or her records request process through PRIA.
The Flight Standards Service (AFS) is committed to a stakeholder-driven system of operation that will deliver FAA records and assistance to all parties subject to PRIA, when necessary.
|120-12A||AFS-820||Private Carriage Versus Common Carriage of Persons or Property Furnishes FAA personal and interested segments of industry with general guidelines for determining whether current or proposed transportation operations by air constitute private or common carriage.||04-24-1986|
|120-30A||AFS-830||Reporting Requirements of Air Carriers, Commercial Operators, Travel Clubs, and Air Taxi Operators of Large and Small Aircraft Clarifies the mechanical reliability reporting requirements contained in Parts 121, 127, and 135 of the Federal Aviation Regulations (FAR) and the accident and incident reporting requirements of Part 830 (old Part 430) of the National Transportation Safety Board (NTSB), Safety Investigation Regulations.||09-08-1976|
ICAO Aircraft Company Three-LetterIdentifier and/or TelephonyDesignator Assignment and U.S. Special Telephony/Call Signs
Advisory Circular 120-26K defines the criteria and procedures for obtaining an International Civil Aviation Organization (ICAO) three-letter identifier and/or telephony designator assignment and for obtaining an FAA Special or Local telephony/call sign.
|120-73||ANM-100||Damage Tolerance Assessment of Repairs to Pressurized Fuselages Provides guidance to operators of certain transport category airplanes operated under 14 CFR Parts 91, 121, 125, and 129. The guidance provides an acceptable means of compliance with the regulations that require incorporating FAA-approved “repair assessment guidelines” into an operator’s FAA-approved maintenance or inspection program. The means of compliance described is intended to provide guidance to supplement the engineering and operational judgment that must form the basis of any compliance findings relative to repair assessments for pressurized fuselages.||12-14-2000|
|120-93||ANM-100||Damage Tolerance Inspections for Repairs and Alterations This advisory circular (AC) provides guidance material for Type Certificate (TC) Holders, Supplemental Type Certificate (STC) Holders, and operators to comply with requirements in the Aging Airplane Safety Act to ensure the airworthiness of aging airplane parts and components. The Aging Airplane Safety Rule that supports the Act specifies incorporating damage tolerance-based inspections into an operator’s continuous airworthiness maintenance program. These inspections will help ensure the integrity of fatigue critical structure on transport category airplanes operated in air transportation. This guidance will provide persons who have developed repairs and alterations with a means to develop damage tolerance data to be used to determine damage tolerance inspections for repairs and alterations that affect fatigue critical structure. This AC will give guidance on developing compliance documents, schedules and plans that will assist in developing and incorporating damage tolerance inspections into maintenance programs of certain transport category airplanes with respect to repairs and alterations.||11-20-2007|
|120-94||ANM-100||Aircraft Electrical Wiring Interconnection Systems Training Program||11-20-1997|
Establishing and Implementing Limit of Validity to Prevent Widespread Fatigue Damage
This advisory circular (AC)offers guidance on compliance with Title 14 Code of Federal Regulations (14 CFR) 26.21, 26.23, 121.1115, and 129.115. It tells design approval holders of transport category airplanes how to establish a limit of validity of the engineering data that supports the structural maintenance program (hereafter referred to as LOV) for those airplanes. It also tells design approval holders how to address maintenance actions that have been determined necessary to support an LOV. It tells operators of those airplanes how to incorporate the LOV into their maintenance programs. Finally, this AC provides guidance to anyone wishing to extend an LOV. Guidance for establishing an LOV for airplanes whose type certificate was applied for after (XXXX) is contained in AC 25.571-1X. Guidance for extending an LOV approved under § 25.571, § 26.21, or § 26.23 can be found here. The actions described in this AC are meant to prevent widespread fatigue damage (WFD) in the transport airplane fleet up to the LOV.