This advisory circular (AC) sets forth an acceptable means of showing compliance with Title 14 Code of Federal Regulations (14 CFR), part 23, for the certification of systems and equipment in normal, utility, acrobatic, and commuter category airplanes and airships.

The material in this AC is neither mandatory nor regulatory in nature and does not constitute a regulation. You may follow an alternate FAA-approved method.

Provides information and guidance concerning an acceptable means of demonstrating compliance with the requirements of Part 23 of the Federal Aviation Regulations (FAR) regarding fatigue and fail-safe evaluation of metallic airplane structure.

This advisory circular (AC) provides information and guidance about acceptable means, but not the only means of compliance with Title 14 of the Code of Federal Regulations (14 CFR) part 23, subpart E, applicable to the powerplant installation in normal, utility, acrobatic, and commuter category airplanes.

It is applicable to the material and process specifications, or other documents, used to ensure sufficient control of composite prepreg materials in normal, utility, acrobatic, and commuter category airplanes.

Establishes an acceptable means, but not the only means, of obtaining FAA airworthiness approval for the installation of a TAWS that has been approved under Technical Standard Order (TSO)-C151A, Terrain Awareness and Warning System, in a Part 23 airplane. The FAA’s TSO process is a means for obtaining FAA design and performance approval for an appliance, system, or product; however, the TSO does not provide installation approval.

This advisory circular (AC) sets forth an acceptable means of showing compliance with Title 14 Code of Federal Regulations (14 CFR) part 23 and Civil Air Regulations (CAR) 3 for the flammability testing of systems and equipment in normal, utility, acrobatic, and commuter category airplanes and airships.

Guidance in AC 23.1311, SAE, and RTCA documents was used in developing the GAMA Publication #12.

Provides information and guidance concerning acceptable means, but not the only means, of complying with Title 14 of the Code of Federal Regulations (14 CFR) part 23 Subpart C and portions of Subpart D.

Provides information and guidance concerning an acceptable means of showing compliance with Part 23 through amdt.23-45 of the Federal Aviation Regulations applicable to replacing reciprocating engines with gas turbine engines (turbopropeller, turbojet, or turbofan).

This AC is one method being utilized to achieve national standardization in normal, utility, acrobatic, and commuter category airplanes. This AC applies to Subpart B and various sections under Subparts A, D, E, F and G from § 23.1 through § 23.1589.

Provides information and guidance concerning compliance with Part 23 of the Federal Aviation Regulations (FAR) applicable to evaluation of empennage design flight loads on configurations where the horizontal tail surfaces are supported by the vertical tail, or have appreciable dihedral.

This material is neither mandatory nor regulatory in nature and does not constitute a regulation.

Fourth, it includes a requirement to submit ICA’s to the FSDO/ASI for acceptance. The change number and the date of the changed material are shown at the top of each changed page.