Maintenance Inspection Notes for McDonnell Douglas DC-8 Series Aircraft
Provides maintenance inspection notes which can be used for the maintenance support program for certain structural parts of the DC-8 series aircraft.
Furnishes guidance to those individuals and organizations having responsibilities under Part 107 of the Federal Aviation Regulations. It also provides recommendations for establishing and improving security for restricted or critical facilities and areas as the security of which is not dealt with in Part 107.
Noise, Hearing Damage, and Fatigue in General Aviation Pilots
Acquaints pilots with the hazards of regular exposure to cockpit noise. Especially pertinent are piston-engine, fixed-wing, and rotary-wing aircraft.
Use of Aircraft Fuel Anti-icing Additives
Provides information on the use of anti-icing additives PFA-55MB and Mil-I-27686 as an acceptable means of compliance with the FARs that require assurance of continuous fuel flow under conditions where ice may occur in turbine aircraft fuel systems.
Maintenance Inspection Notes for Boeing
Provides maintenance inspection notes which can be used for the maintenance support program for certain structural parts of the B-707/720 series aircraft.
Aircraft Position and Anticollision Light Measurements
Contains useful information concerning measurements for intensity, covering, and color of aircraft position and anti-collision lights.
Dual Locking Devices on Fasteners
Provides guidance and acceptable means, not the sole means, by which compliance may be shown with the requirements for dual locking devices on removable fasteners installed in rotorcraft and transport category airplanes.
Maintenance Certification Procedures
Provides guidance for the preparation of an Operations Specification--Preface Page which will afford nominal and reasonable relief from approved service and overhaul time limits when a part is borrowed from another operator.
Amendment of Federal Aviation Regulation Part 171 (FAR-171) - Cost of Flight and Ground Inspections
Alerts the public to the amendment to FAR Part 171 pertaining to the payment of ground and flight inspection charges prior to the issuance of an approved IFR procedure.
Installation Approval on Transport Category Airplanes of Cargo Unit Load Devices Approved as Meeting the Criteria in NAS 3610
Sets forth an acceptable means, but not the sole means, of complying with the requirements of the Federal Aviation Regulations (FAR’s) applicable to the installation on transport category airplanes of cargo load devices approved as meeting the criteria in NAS 3610.
Conspicuity of Aircraft Instrument Malfunction Indicators
Provides design guidance information on methods of improving conspicuity of malfunction indication devices.
Turbine Engine Foreign Object Ingestion and Rotor Blade Containment Type Certification Procedures
Provides guidance and acceptable means, not the sole means, by which compliance may be shown with the design and construction requirements of Part 33 of the Federal Aviation Regulations.
JIG Fixtures; Replacement of Wing Attach Angles and Doublers on Douglas DC-3 Series Aircraft, Airworthiness Directive 66-18-2
Describes methods of determining that jig fixtures used in the replacement of the subject attached angles and doublers meet the requirements of Airworthiness Directive 66-18-2.
Cockpit Voice Recorder Installations
Sets forth one acceptable means of compliance with provisions of FAR 25.1457 (b), (e), and (f) pertaining to area microphones, cockpit voice recorder location, and erasure features.
Special Flight Permits for Operation of Overweight Aircraft
Furnishes guidance concerning special flight permits necessary to operate an aircraft in excess of its usual maximum certificated takeoff weight.
Maintenance and Handling of Airdriven Gyroscopic Instruments
Advises operators of general aviation aircraft of the need for proper maintenance of air-driven gyroscopic instruments and associated air filters.
Criteria for Acceptance of Ownership and Servicing of Civil Aviation Interest(s) Navigational and Air Traffic Control Systems and Equipment
Contains a revised FAA policy under which the FAA accepts conditional ownership of equipment and systems from civil aviation interests, without the use of Federal funds, and operates, maintains, and provides the logistic support of such equipment.
Turbine and Compressor Rotors Type Certification Substantiation Procedures
Sets forth guidance and acceptable means, not the sole means, by which compliance may be shown with the turbine and compressor rotor substantiation requirements in FAR Part 33.
Accessibility to Excess Emergency Exits
Sets forth acceptable means of compliance with the “readily accessible” revisions in the Federal Aviation Regulations dealing with excess emergency exits.
Accidents Resulting from Wheelbarrowing in Tricycle Gear Equipped Aircraft
Explains “wheel barrowing”, the circumstances under which it is likely to occur, and recommended corrective action.
Category II Operations - General Aviation Airplanes
Sets forth acceptable means by which Category II operations may be approved in accordance with FAR Parts 23, 25, 61, 91, 97, and 135.
Recommended Standards for IFR Aeronautical Charts
Sets forth standards recommended by the Federal Aviation Administration for the guidance of the public in the issuance of IFR aeronautical charts for use in the National Airspace System (NAS)
Practice Guide for Decontaminating Aircraft
The title is self-explanatory.
Qualification Testing of Turbo-jet Engine Thrust Reversers
Discusses the requirements for the qualification of thrust reversers and sets forth an acceptable means of compliance with the tests prescribed in Federal Aviation Regulations, Part 33, then run under nonstandard ambient air conditions.
Measurement of Cabin Interior Emergency Illumination in Transport Airplanes
Outlines acceptable methods, but not the only methods, for measuring cabin interior emergency illumination on transport airplanes, and provides information as to suitable measuring instruments.