Section 2. Visual Separation

7-2-1. VISUAL SEPARATION

Visual separation may be applied when other approved separation is assured before and after the application of visual separation. To ensure that other separation will exist, consider aircraft performance, wake turbulence, closure rate, routes of flight, known weather conditions, and aircraft position. Weather conditions must allow the aircraft to remain within sight until other separation exists. Visual separation is not authorized when the lead aircraft is a super.

  1. TERMINAL. Visual separation may be applied between aircraft up to but not including FL180 under the following conditions:
    1. Tower-applied visual separation.
      1. Maintain communication with at least one of the aircraft involved or ensure there is an ability to communicate immediately with applicable military aircraft as prescribed in paragraph 3-9-3, Departure Control Instructions, subparagraph a2.
      2. The tower visually observes the aircraft, issues timely traffic advisories, and provides visual separation between the aircraft.
      3. Issue control instructions as necessary to ensure continued separation between the applicable aircraft.
      4. Do not apply visual separation between successive departures when departure routes and/or aircraft performance preclude maintaining separation.
      5. The use of tower-applied visual separation is not authorized when wake turbulence separation is required.
      6. ATCTs at adjacent airports may be authorized to apply visual separation between their traffic and the other facility's traffic. All provisions of FAA Order JO 7110.65, paragraph 7-2-1a1, still apply.
    2. Pilot-applied visual separation.
      1. Maintain communication with at least one of the aircraft involved and ensure there is an ability to communicate with the other aircraft.
      2. The pilot sees another aircraft and is instructed to maintain visual separation from the aircraft as follows:
        1. Tell the pilot about the other aircraft. Include position, direction, type, and, unless it is obvious, the other aircraft's intention.
        2. Obtain acknowledgment from the pilot that the other aircraft is in sight.
        3. Instruct the pilot to maintain visual separation from that aircraft.
      3. If the pilot reports the traffic in sight and will maintain visual separation from it (the pilot must state both), the controller may “approve” the operation instead of restating the instructions.
      4. If aircraft are on converging courses, inform the other aircraft of the traffic and that visual separation is being applied.
      5. Advise the pilots if the targets appear likely to merge.
      6. Control of aircraft maintaining visual separation may be transferred to an adjacent position/sector/facility. Coordination procedures must be specified in an LOA or facility directive.
  2. EN ROUTE.Visual separation may be used up to but not including FL 180 when the following conditions are met:
    1. Direct communication is maintained with one of the aircraft involved and there is an ability to communicate with the other.
    2. A pilot sees another aircraft and is instructed to maintain visual separation from it as follows:
      1. Tell the pilot about the other aircraft including position, direction, and type. If it is not obvious, include the other aircraft's intentions.
      2. Obtain acknowledgment from the pilot that the other aircraft is in sight.
      3. Instruct the pilot to maintain visual separation from that aircraft.
      4. If the pilot reports the traffic in sight and will maintain visual separation (the pilot must state both), the controller may “approve” the operation instead of restating the instructions.
      5. If the aircraft are on converging courses, inform the other aircraft of the traffic and that visual separation is being applied.
      6. Advise the pilots if the radar targets appear likely to merge.
      7. Advise the pilots if either aircraft is a heavy.
      8. Issue wake turbulence cautionary advisories in accordance with paragraph 2-1-20.
  3. Nonapproach control towers may be authorized to provide visual separation between aircraft within surface areas or designated areas when approved separation is provided before and after the application of visual separation. The nonapproach control tower must apply the procedures contained in subparagraph a1 or a2, when applying visual separation.
  4. If the nonapproach control tower controller states to the radar controller that they will provide visual separation between arrivals, departures/arrivals and/or successive departures, and states the call signs of all aircraft involved, the radar controller can approve the application of visual separation as requested.