« Back to Advisory Circulars main page

76 - 100 of 121 results.

Export (CSV)

Search results
Number Office Title Date
150/5020-1 APP-400 Noise Control and Compatibility Planning for Airports
Provides general guidance for noise control and compatibility planning for airports as well as specific guidance for preparation of airport noise exposure maps and airport noise compatibility programs by airport operators for submission under Title 14, Code of Federal Regulations, Part 150, and the Aviation Safety and Noise Abatement Act of 1979. Contains an expanded Table of Land Uses Normally Compatible with Various Levels of Noise.
150/5200-28E AAS-300 Notices to Airmen (NOTAMs) for Airport Operators

This AC provides guidance on using the Notice to Airmen (NOTAM) system for reporting airport facilities changes or outages and for airport condition reporting. It explains procedures used to describe, format, and disseminate information on unanticipated or temporary changes to components of, or hazards in, the National Airspace System (NAS). 

150/5370-13A AAS-100 Off-Peak Construction of Airport Pavements Using Hot-Mix Asphalt
Provides guidance for the planning, coordination, management, design, testing, inspection, and execution of off-peak construction of airport pavements using hot-mix asphalt (HMA) paving materials. Also focuses on HMA airfield pavement construction and applies to other types of airfield improvements where off-peak construction is identified as the preferred delivery method.
150/5370-2F AAS-100 Operational Safety on Airports During Construction

Provides guidelines for operational safety on airports during construction. Principal changes include prohibiting construction in safety areas when associated runway or taxiway is open, providing guidance for incorporating safety risk management, and including checklists for writing Construction Safety and Phasing Plans (CSPP) and for daily inspections.

150/5210-5D AAS-100 Painting, Marking, and Lighting of Vehicles Used on an Airport

Provides guidance, specifications, and standards for painting, marking, and lighting of ground vehicles operating in the airport air operations area (AOA). The approved lights, colors, and markings described in the AC assure the conspicuity of vehicles operating in the AOA from both the ground and the air. The AC contains new specifications and recommendations for the painting, marking, and lighting of Towbarless Tow Vehicles (TLTVs).

150/5210-25 AAS-100 Performance Specification for Airport Vehicle Runway Incursion Warning Systems (RIWS)

This AC contains minimum performance specifications for systems and equipment airports use to provide a warning to drivers on an airfield about a potential runway incursion. This AC discusses two types of detection systems: a preconfigured, commercial off the shelf (COTS) system; and a system with custom hardware and software.

150/5360-13 APP-400 Planning and Design Guidelines for Airport Terminal Facilities

Provides guidelines for the planning and design of airport terminal buildings and related access facilities. Consolidated file includes Change 1.

Note: Portions of this AC are under review for update. Please contact the National Planning and Environmental Division for assistance.

Because of the size of the document, it is available as one large file (see Complete) or as several smaller files (Part 1-4).

150/5360-9 APP-400 Planning and Design of Airport Terminal Facilities at Non-Hub Locations

Provides guidance material for the planning and design of airport terminal buildings at non-hub locations.

Note: Portions of this AC are under review for update. Please contact the National Planning and Environmental Division for assistance.

Because of the size of this document (5.28 MB), it is available as one large file (see Complete) or as several smaller files (see Parts 1-4).

150/5345-28G AAS-100 Precision Approach Path Indicator (PAPI) Systems

Contains the FAA standards for the Precision Approach Path Indicator (PAPI) systems, which provides pilots with visual glideslope guidance during approach for landing.

See also--

150/5210-17C AAS-300 Programs for Training of Aircraft Rescue and Firefighting Personnel

This AC provides information on courses and reference materials for training of Aircraft Rescue and Firefighting (ARFF) personnel. This revision replaces Appendix 1  with an Addendum of Aircraft Rescue and Firefighting (ARFF) Training Facilities, which the FAA will update on a quarterly basis. It also  removes the one minute time requirement for donning of Personal Protective Equipment and the Self-Contained Breathing Apparatus.

150/5200-36A AAS-300 Qualifications for Wildlife Biologist Conducting Wildlife Hazard Assessments and Training Curriculums for Airport Personnel Involved in Controlling Wildlife Hazards on Airports (Consolidated AC includes Change 1)

Describes the qualifications for wildlife biologists who conduct Wildlife Hazard Assessments (WHA) for airports certificated under 14 CFR Part 139 and at non-certificated airports funded by the Airport Improvement Program (AIP) or Passenger Facility Charge (PFC) Program. Addresses the minimum wildlife hazard management curriculum for the initial and recurrent training of airport personnel who implement an FAA-approved Wildlife Hazard Management Plan (WHMP).

Consolidated AC includes Change 1 dated 1/31/2013. See also--

CHANGE 1 (01-31-2013)

This Change adds language requiring certificated airports to maintain documentation of airport wildlife biologist qualifications. This change is in response to an Office of the Inspector General safety recommendation.

150/5370-12B AAS-100 Quality Management for Federally Funded Airport Construction Projects

This advisory circular (AC) provides information on the planning and oversight of construction projects at airports accomplished under the FAA's Airport Improvement Program (AIP). In addition to the previous version, this AC cancels:

  • AC 150/5300-9B, Predesign, Prebid, and Preconstruction Conferences for Airport Grant Projects
  • AC 150/5370-6D, Construction Progress and Inspection Report-Airport Improvement Program (AIP)

150/5370-16 AAS-100 Rapid Construction of Rigid (Portland Cement Concrete) Airfield Pavements
Provides guidance for the planning, coordination, management, design, testing, inspection, and execution of rapid construction of rigid (Portland Cement Concrete) airfield pavements. This AC focuses on rigid airfield pavement construction. The material contained herein also applies to other types of airfield improvements where rapid construction is identified as the preferred construction method.
150/5200-32B AAS-300 Reporting Wildlife Aircraft Strikes

This AC explains the importance of reporting collisions between aircraft and wildlife, more commonly referred to as wildlife strikes. It also explains recent improvements in the FAA’s Bird/Other Wildlife Strike Reporting system, how to report a wildlife strike, what happens to the wildlife strike report data, how to access the FAA National Wildlife Strike Database (NWSD), and the FAA’s Feather Identification program.

150/5325-4B AAS-100 Runway Length Requirements for Airport Design
Provides design standards and guidelines for determining recommended runway lengths.
150/5395-1A AAS-100 Seaplane Bases

This AC provides guidance to assist operators in planning, designing, and constructing seaplane bases and associated facilities.

150/5340-5D AAS-100 Segmented Circle Airport Marker System

This AC provides standards for a system of airport marking consisting of certain pilot aids and traffic control devices.

150/5345-49C AAS-100 Specification L-854, Radio Control Equipment
Contains the specifications for radio control equipment to be used for controlling airport lighting facilities.
150/5345-42H AAS-100 Specification for Airport Light Bases, Transformer Housings, Junction Boxes, and Accessories

This advisory circular contains the specifications for airport light bases, transformer housings, junction boxes, accessories, elevated light fixture covers and stakes.  It is not intended to be a compilation of currently available product designs.  Instead, it provides the basic standard requirements for critical dimensions and performance requirements to which all manufacturers must demonstrate compliance. 

150/5345-12F AAS-100 Specification for Airport and Heliport Beacons

Contains equipment specifications for light beacons that are used to locate and identify civil airports, military airports, seaplane bases, and heliports.

150/5345-10H AAS-100 Specification for Constant Current Regulators and Regulator Monitors

Contains a specification for constant current regulators (CCR) and a monitor for use with airport lighting circuits.

See also Engineering Brief 67, Light Sources Other than Incandescent and Xenon for Airport and Obstruction Lighting Fixtures.

150/5345-51B AAS-100 Specification for Discharge-Type Flashing Light Equipment

Contains the specifications for discharge-type flashing light equipment to be used for runway end identification lights (REIL) and for an omni-directional approach lighting system (ODALS).

See also Notice to Manufacturers of Airport Lighting and Navigation Aid Equipment about AIP Buy American Requirement (12/19/2011). The FAA is requesting information to determine if waivers to this requirement are needed.

150/5345-3G AAS-100 Specification for L-821, Panels for the Control of Airport Lighting

Provides the specified manufacturing requirements for panels used for remote control of airport lighting and auxiliary systems.

150/5345-7F AAS-100 Specification for L-824 Underground Electrical Cable for Airport Lighting Circuits

This AC provides specifications for L-824 underground electrical cable for airport lighting circuits.

150/5345-13B AAS-100 Specification for L-841 Auxiliary Relay Cabinet Assembly for Pilot Control of Airport Lighting Circuits
Contains the specification requirements for a relay cabinet used to control airfield lighting circuits. The L-841 consists of an enclosure containing a direct current (DC) power supply, control circuit protection and 20 pilot relays.

76 - 100 of 121 results.

Export (CSV)